KNITTING - How to Knit Cables

Cabling requires a double-pointed needle to hold the first stitches out of
the way until they are needed. The cable needle should be about the same size or
smaller than the working needles, certainly not larger, as this would be
difficult to knit from after the stitches are crossed. Cables differ in the
number of stitches being used, the number of rows between the crossover and the
direction of the crossover, left or right. Generally, cables are worked over an
even number of stitches, with half the number crossed over or under the
remainder, although this can vary to give many interesting effects.

Cables are normally worked in stocking stitch on a background of reverse
stocking stitch. If cables are worked during shaping (as in a V-neck or armhole)
there may not be enough stitches to work the complete cable. In this case you
should work the odd stitches in stocking stitch (or whatever other background
stitch you are using), as it is obviously not possible to work half a cable.

Making a front cross cable over 4 stitches (C4F)

This will produce a left twist cable.

1. Working in stocking stitch on a ground of reverse stocking stitch, place the
first 2 stitches on a cable needle and leave them at the front of the knitting
(Fig.60).

2.Knit the next 2 stitches from the left hand needle (Fig.61).

3. Knit the 2 stitches from the cable needle, taking care to knit them in the
same order as they came off the needle (Fig.62).

Making a back cross cable over 4 stitches (C4B)
This will produce a right twist cable.
1. Place the first 2 stitches on a cable needle and leave them at the back of
the knitting (Fig.63).

2. Knit the next 2 stitches from the left hand needle, followed by the 2
stitches on the cable needle in the correct order as before.

All content provided by TB Ramsden & Co.